Truss hand calculations via the method of joints are available in the results section.
Reaction forces will first be attempted by analysing the free body diagram (FBD) of the overall structure. Joints (aka nodes) are then analysed via FBD's to determine any axial forces (or previously unsolved reaction forces). This process continues across the joints until all axial forces have been solved. The following assumptions are made:
All members are connected by pins. This implies that the member fixities are "FFFFRR" or "FFFFFR"
All members are two force members and thus only support axial loads. This implies that only point loads that are applied to the nodes are allowed.
If either of the above conditions are not met, then the "Hand Calculation" button will not show
In addition, it should be noted that:
Statically indeterminate members cannot be fully solved by the "Method of Joints" however, the hand calculations will still attempt as many solutions as possible for reactions and axial forces.
All axial forces will be assumed to be in tension. This means that all positive results will confirm tension, negative results will determine compression, and zero results will determine 0 force members.
In some cases, the "Method of Joints" is unable to provide a solution, and this is a limitation on the method. In these instances, the "Method of Sections" may be more appropriate.
Example
1) Model your truss in S3D.
2) Click "Solve" to transition to the results section. The reactions and axial buttons have been clicked on to show these results.
3) Click the "Truss Hand Calcs" button highlighted in the image. Note that the button will only show if the members have fixities "FFFFRR" or
"FFFFFR" representing pin fixities, and the structure is drawn in the x-y plane (i.e. all nodes must have the same z value).
4) A pop up will come up with the hand calculations. On the left is a menu you can click through to go through the introduction, evaluation of your structure (if there are any issues with stability or determinancy) and then the free body digrams and equilibrium equations for reactions and joints. The final summary menu item will provide a summary of all the axial and reaction results. Note, if the "Summary" menu does not appear, it means there were issues with completely solving your structure. This is likely due to the structure being statically indeterminant. In these cases, the hand calculations will still work, however not all axial forces will be found.
